9
SPECIFIC SAFETY RULES
PREPARATION OF THE LOG
Both ends of the log should be cut as square as possible to prevent the log from
rotating out of the splitter during operation.
Never split logs greater than the specified log capacity.
Do not operate the log splitter on icy, wet, muddy, or slippery ground. Only operate
your log splitter on level ground.
Operating on a slope could cause the log splitter to roll over or logs to fall o the
equipment, which could result in injury.
Do not move the log splitter over hilly or uneven terrain without a tow vehicle or
adequate help.
Keep the work area free of clutter. Remove split wood from around the log splitter
immediately after each use to avoid potential tripping.
OPERATOR ZONE
This unit is designed to be operated by one person located in the operator zone as
shown in the following diagrams.
Operate the unit only when standing in the operator zone.
Always stop the unit and allow moving parts to stop before leaving operation zone.
Do not leave a running unit unattended.
Many accidents occur when more than one person operates the log splitter.
The adult who loads and stabilizes the log must be the person who operates the
control handle.
Many accidents occur when more than one person operates the log splitter.
The adult who loads and stabilizes the log must be the person who operates
the control handle.
5240-552 EnProdManual P.indd 95240-552 EnProdManual P.indd 9 2021-06-11 12:14 PM2021-06-11 12:14 PM