BENDIXKing KNS 80 - Flying to Waypoint 1

I
(10)
10. Load waypoint 2 distance (40.0 nm) by again pushing the DATA
button. The last selected waypoint
2 distance will appear in the
data display and "DST" annunciated. Then select your new
waypoint
2 distance using the data input controls.
You now have all data for your second waypoint loaded and
in memory. Following the same procedure you may load all four
waypoints.
Remember-you can check or change any RNAV waypoint
data, in any sequence simply by calling up (displaying) that data
using the DSP and DATA buttons. Any displayed data can be
changed by use of the data input controls.
I I I7 1-1
-/ l-1. IJ
-:- '-:-. ,-~ , D:, *I
ENR
I RNV USE DSP
KNS 80 NAV SYSTEM
I '-1 1-1 1-1
NM MIN
ENR I I
RNV USE DSP
NAV SYSTEM
Take off and fly to waypoint 1
11. Before takeoff, check to be sure that RNV/ENR is still the active
mode, then depress the DSP button to place waypoint
"1" in
the
DSP position. Your selected waypoint 1 frequency will
automatically appear in the data display.
You may now want to depress the DATA button
to check
radial, and again
to check distance in the data display.
Now depress the USE button to place waypoint
"1" in the
USE position. The number
"1" in the DSP position will stop
blinking, indicating that the displayed data and "in use" data are
the same.
You take off, and as you reach line-of-sight altitude your DME
will lock on. The dashes that were present in
the distance display
of the KNS 80 will disappear and display distance to
15