Change over to waypoint
2
13.
At
30
nm outbound from waypoint 1, you decide
to
change over
to
waypoint
2:
Depress the
DSP
button and the number
2
will appear
(blinking) over the DSP annunciation and your waypoint
2
frequency will appear in the data display. Your DME display will
not change because waypoint 1 data is still “in use.” At this point,
if you desire, you can recheck your waypoint
2
radial and
distance data in the data display by depressing the DATA button
for each.
data “in use”. The number
2
will appear in the
USE
annunciated
space; the number
2
in the DSP space will stop blinking.
Waypoint
2
frequency (1 16.90) will automatically appear.
Following VOR/DME receiver acquisition of your new
VORTAC frequency, your distance display will begin reading
distance (NM), groundspeed (KT) and
TTS
(MIN)
to
waypoint
2.
Your CDI TO/FROM flag will move
to
the TO position and you
can continue flying your course directly to waypoint
2.
When satisfied, depress the
USE
button
to
put waypoint
2
Flying direct to
a
VOR/DME
facility
to fly direct to Springfield VORTAC.
2
frequency,
so
all you do is depress the VOR button.
14.
You are approaching waypoint
2
and decide (or are instructed)
You are already tuned
to
116.90
SGF
which is your waypoint
CAUTION:
When flying directly to or from a
VORTAC facility, it
is
preferable
to
select either
the
VOR
or VOWPAR mode.
17
To Next Page
Loading...