SP-7XE/F Full-Rise Scissor Lift 6 P/N 5900010 — Rev. B3 — September 2023
7. Let the equipment cool completely before putting it away. Loop cord loosely around equipment
when storing.
8. To reduce the risk of fire, do not operate in the vicinity of open containers of flammable liquids
(gasoline).
9. Adequate ventilation should be provided when working on operating internal combustion engines.
10. Keep hair, loose clothing, fingers, and all parts of body away from moving parts.
11. To reduce the risk of electric shock, do not use on wet surfaces or expose to rain.
12. Use only as described in this manual. Use only BendPak recommended attachments and
accessories.
13. ALWAYS WEAR SAFETY GLASSES. Everyday eyeglasses only have impact resistant lenses, they
are not safety glasses.
14. To reduce the risk of injury, close supervision is necessary when this product is used around
children.
15. To reduce the risk of injury, never attempt to lift more than the rated capacity. Refer to loading
instructions.
16. The Lift uses electrical energy; if your organization has Lockout/Tagout policies, make sure to
implement them after connecting the Lift to a power source.
17. Refer to markings for proper load on electrical receptacles.
18. Only operate your Lift between temperatures of +41°F to +104°F (+5°C to +40°C).
19. The Lift should only be operated by authorized personnel. Keep children and untrained personnel
away from the Lift.
20. Do not make any modifications to the Lift; this voids the warranty and increases the chances of
injury or property damage.
21. Do not use the Lift while tired or under the influence of drugs, alcohol, or medication.
22. Consider the work environment. Keep the work area clean. Cluttered work areas invite injuries.
Keep areas well lit.
23. Always make sure both Lift platforms are secured on their Safety Locks before attempting to
work on or near a Vehicle.
24. Make a thorough inspection of the product at least once a year. Replace any damaged or severely
worn parts, decals, or warning labels. Replace worn or damaged parts with BendPak or BendPak
approved parts and assemblies only.
25. BendPak recommends referring to the ANSI/ALI ALIS Standard Safety Requirements for
Installation and Service for more information about safely installing, using, and servicing your Lift.
26. The SP-7XE and SP-7XEF are full-rise, frame-engaging, Scissor Lifts for servicing Vehicles. Use it
only for its intended purpose. Improper use of this Lift could cause severe injury or death.
27. You
must wear OSHA-approved (publication 3151) personal protective equipment at all times
when installing, using, maintaining, or repairing the Lift. Leather gloves, steel-toed work boots, eye
protection, back belts, and hearing protection are
mandatory.
28. Keep loads balanced on the Lift Platforms. Clear the area immediately if a Vehicle is in danger of
falling off the Lift.
29. Do not make any modifications to the Lift. Modifications void the warranty and increases the
chances of injury or property damage. Do not modify any safety-related features in any way.
To Next Page
Loading...
