SP-7XE/F Full-Rise Scissor Lift 50 P/N 5900010 — Rev. B3 — September 2023
Operation
This section describes how to operate your Lift.
⚠ WARNING Use care around the Lift. When the Lift is moving, keep everyone at least
30 feet away from it.
Lift Operation Safety
BendPak recommends referring to the ANSI/ALI ALIS Standard Safety Requirements for Installation
and Service available from ALI for more information about safely installing, using, and servicing the
Lift.
Before you raise or lower a Vehicle using your Lift, do the following:
• Check the lift. Check the Lift for any missing, heavily worn, or damaged parts. Do not operate
the Lift if you find any issues; instead, take it out of service, then contact your dealer, email
support@bendpak.com, visit bendpak.com/support, or call (800) 253-2363, select
option 7 then 4.
• Check the area. Check the area around the Lift for obstructions; anything that might block the
Lift. Do not forget to check above the Lift. If you find an obstruction, move it out of the way. Do
not allow anyone within 30 feet of the Lift while it is in motion.
• Check the operators. Make sure everyone who is going to operate the Lift has been trained in
its use, has read the labels on the unit, and has read the manual. Only the operator at the Console
should be within 30 feet of the Lift when it is in motion.
• Check for safety. Make sure everyone who is going to be walking near the Lift is aware and
takes appropriate safety measures. Only put Vehicles on the Lift. When raising the Lift, do
not leave it until it is engaged on a Safety Lock. When lowering the Lift, do not leave it
until it is fully lowered. Do not allow children to operate the Lift. Do not allow anyone under the
influence of drugs or alcohol to operate the Lift.
• Check the Vehicle. Never exceed the Lift’s weight rating. Do not allow people inside a Vehicle
you are going to raise. Make sure the Vehicle is not overbalanced on either end. Make sure you
know and use the manufacturer’s recommended Lifting Points for the Vehicle. Never raise just one
side, one corner, or one end of a Vehicle.
About Lifting Points and Lift Blocks
The raised Vehicle must be balanced on Lifting Blocks that ride on the Lift Platform.
⚠ WARNING You must use all four Lift Blocks when raising a Vehicle. Never use just one, two,
or three Lift Blocks to raise a Vehicle. The Vehicle will be unstable and could slip off
the Lift, possibly damaging the Lift, damaging the Vehicle, and injuring anyone
under it.
⚠ WARNING Do not ‘eyeball’ the best location for the Adapters. You must use the
manufacturer’s recommended Lifting Points. If you do not, the Vehicle
could become unstable and fall, which could damage the Vehicle, damage the Lift,
or injure or even kill anyone under the Vehicle.
To Next Page
Loading...
