SP-7XE/F Full-Rise Scissor Lift 15 P/N 5900010 — Rev. B3 — September 2023
Installation
This section describes how to install your SP-7XE/F. Perform the steps in the order listed.
⚠ WARNING Use only the factory-supplied parts that came with your lift. If you use
parts from a different source, you void your warranty and compromise the safety of
everyone who installs or uses the Lift. If you are missing parts, visit
bendpak.com/support or call (800) 253-2363, option 7, then 5.
Your Lift is supplied with installation instructions and concrete fasteners that meet the criteria set by
the current version of the American National Standard “Automotive Lifts – Safety Requirements for
Construction, Testing, and Validation.”
Lift buyers are responsible for regional, structural, and/or seismic anchoring requirements specified by
any other agencies or codes, such as the Uniform Building Code or International Building Code.
Safety Rules
When installing the Lift, your safety depends on proper training and thoughtful operation.
⚠ WARNING Do not install this equipment unless you have automotive Lift installation training.
Always use proper tools, such as a Forklift or Shop Crane, to move heavy
components. Do not install this equipment without reading and understanding this
manual and the safety labels on the unit.
BendPak recommends referring to the ANSI/ALI ALIS Standard Safety Requirements for Installation
and Service for more information about safely installing, using, and servicing your Lift.
Only fully trained personnel should be involved in installing this equipment. Always pay attention.
Use appropriate tools and equipment. Stay clear of moving parts.
⚠ WARNING You must always wear protective equipment during the installation: leather gloves,
steel-toed work boots, eye protection, back belts, and hearing protection.
Electrical Work
You will need to have a licensed, certified Electrician available at some point during the installation.
⚠ DANGER All wiring must be performed by a licensed Electrician in accordance with all
applicable national, state, and local electrical codes.
The Electrician needs to:
1. Connect the Power Unit to a 220 VAC power source. This is generally done near the end
of the installation. Note that installing the Power Unit and connecting the Power Unit are separate
procedures; while anyone can install the Power Unit, the Electrician must connect the Power Unit
to Power. The Electrician must provide a Power Cord with an appropriate plug.
2. Install a Power Disconnect Switch. A Power Disconnect Switch gives you a way to shut
down the Lift in the event of an electrical circuit fault or emergency. Refer to Install a Power
Disconnect Switch for more information.
To Next Page
Loading...
