SP-7XE/F Full-Rise Scissor Lift 9 P/N 5900010 — Rev. B3 — September 2023
SP-7XE Series Lift components include:
• Console — Hosts the controls for the Lift (on top) and the Power Unit (inside). The connections
for the Hydraulic Hoses and the Air Lines connect to the Power Unit inside the Console.
• Power Unit — Provides Hydraulic pressure to the Hydraulic Cylinders, which are used to raise
the Platforms. Housed inside the Console. Connects to an external power source and to the Lift
Controls.
• Hose Covers — Covers the Air and Hydraulic Hoses.
• Drive-up Ramps — Used to drive on or off the Platforms. Not included with the SP-7XEF.
• Hinged Section — Hinges up when the Platforms are raised.
• Fixed Section — On the opposite end from the Hinged Section. Can be raised for installation,
but otherwise stays in place. Does not hinge up when the Platforms are raised.
• Platforms — Flat steel plates that raise and lower. The Platforms, or the Lift Pads on the
Platforms, contact the undercarriage of the Vehicle to raise and lower it.
• Ramp Extensions — Attaches to the Platforms, used for supporting Vehicles with longer
wheelbases.
• Bases — The bottoms of the Lift. They hold the Scissor Legs, Hydraulic Cylinders, Air Cylinders,
Safety Locks, and the bolt holes for the Anchor Bolts. The Lift is bolted into place using the Anchor
Bolt holes in each Base.
• Frames — Combination of a Platform and a Base.
• Scissor Legs — The mechanism of the Lift that raises and lowers, powered by the Hydraulic
Cylinders.
• Hydraulic Cylinders — Push the Platforms up to raise a Vehicle, move down to lower a
Vehicle.
• Safety Locks — Hold the Platforms in place and consist of a latching mechanism and welded
blocks on each Lift Platform assembly. The SP-7XE/F has eight Safety Lock positions, which allow
selection of the ideal Platform height for your use.
• Air Cylinders — Part of the Safety Lock Mechanism uses pressurized air to move the Safety
Lock Mechanism off the Safety Lock to lower the Lift. It is the user’s responsibility to provide an air
pressure supply (minimum 50 psi / 10 CFM, regulated to a maximum of 125 psi).
• Lift Pads — Rubber Pads that contact the Lifting Points on the Vehicle being raised. The Lift is
supplied with four Lift Pads.
To Next Page
Loading...
