Beninca CALL User Manual

HOW TO DISABLE THE TX PRESENT IN THE RECEIVER CONNECTED TO THE MODULO:
This command permits to disable a transmitter. This will remain stored in the receiver memory but it will not
activate any channel (to restore it, use command “addtx”)
distx 123456 02D762D
where:
distx command string
123456 access password
02D762D string of 7 hexadecimal digits (0 – F) representing the SN of the TX to be
disabled from the receiver memory
N.B.: To reset a disabled transmitter, enter it again with command “addtx”
If a reply should be sent by the device, the command shall be:
?distx 123456 02D762D
The reply will be: “COMMAND OK”
REQUEST OF TRANSMITTER STATUS IN RECEIVER CONNECTED TO THE MODULE:
This command permits to know whether a specic transmitter is enabled or not
testtx 123456 02D762D
where:
testtx command string
123456 access password
02D762D string of 7 hexadecimal digits (0 – F) representing the SN of the TX to
request the status
The reply will be one of the following
“TRANSMITTER ENABLED”
“TRANSMITTER DISABLED”
“TRANSMITTER NOT PRESENT”
ACTIVATION OF THE TRANSMITTER ENTER BLOCKTHROUGH RECEIVER:
This command permits to block the access to the radio menu functions of the receiver making it possible to
enter the new transmitters only through mobile phone (command “addtx”).
setrxpsw 123456
where:
setrxpsw command string
123456 access password
REPLY:
“COMMAND OK”
DEACTIVATION OF TRANSMITTER ENTER BLOC THROUGH RECEIVER:
This command permits to reactivate the access to the radio menu functions of the receiver making it possi-
ble to store in memory new transmitters through both the use of a mobile phone and the normal functions
of the receiver.
resetrxpsw 123456
where:
resetrxpsw command string
123456 access password
RISPOSTA:
“COMMAND OK”
10
11

Beninca CALL Specifications

General

Brand	Beninca
Model	CALL
Category	Receiver
Language	English