Beninca CALL User Manual

RESET OF SENT SMS COUNTER:
This command permits to reset the counter of SMS sent by the CALL device. This counter can be useful to
count the messages sent since the last recharge made in order to estimate the remaining credit.
smsreset 123456
where:
smsreset command string
123456 access password
If a reply should be sent by the device, the command shall be:
?smsreset 123456
The reply will be: “COMMAND OK”
OUTPUT COMMAND MESSAGE:
This command permits to modify the text of channel activation SMS, so as to be able to combine a specic
output to an ID word of the device to be activated or deactivated.
(example: if the gate is connected to channel 1, the SMS linked to channel 1 can be modied with the word-
ing “GATE”)
setcmdmsg 123456 1 GATE
where:
setcmdmsg command string
123456 access password
1 SMS to be modied (1-4)
GATE channel activation string (20 digits max)
N.B.: the text of the 4 SMS is the default text: Ch1, Ch2, Ch3 and Ch4 (words corresponding to SMS1,
SMS2, SMS3, SMS4, respectively)
If a reply should be sent by the device, the command shall be:
?setcmdmsg 123456 1 GATE
The reply will be: “COMMAND MESSAGE SET”
ADD TRANSMITTER CODE IN THE RECEIVER CONNECTED TO MODULE:
This command permits to add a transmitter code to the receiver memory without necessarily gain access to
the control unit (the serial number of the transmitter to be entered must be known). Through this command
only 2-channel transmitters can be entered. To enter 4-channel transmitters proceed through the radio
Menu of the receiver (see instructions of RR.4).
addtx 123456 02D762D
where:
addtx command string
123456 access password
02D762D string of 7 hexadecimal digits (0 – F) representing the SN of the TX to be
added to the receiver memory
N.B.: the following is added by default to the TX added : key1>channel, key 2>channel 2.
The serial number of remote controls is indicated outside the remote controls in series, or it can be read
through the ADVANTAGE system.
If a reply should be sent by the device, the command shall be:
?addtx 123456 02D762D
The reply will be: “COMMAND OK”
8
9

Beninca CALL Specifications

General

Brand	Beninca
Model	CALL
Category	Receiver
Language	English