REQUEST OF GENERAL STATUS OF THE MODULE:
This command signal permits to receive some information on the device:
the number of messages sent, the number of transmitter codes preset in memory, the software and
rmware version of the GSM module, the network operator to which the device is connected, the number
of mobile phones stored in memory.
status 123456
where:
status command string
123456 access password (this is the default password if it has not modied yet or if
the module has been just initialized)
REPLY:
Sms sent: 0; Tx rec: 0; Sw:1.0.0; Fw:1.0.0.; Op:vodafone; phs:n/200
where:
Sms sent: 0 number of SMS sent from the last time counters have been reset
Tx rec: 0 number of transmitters stored in the receiver
Sw:1.0.0 software version of the GSM board
Fw:1.0.0. rmware of the GSM module
Op:vodafone network operator
phs:n/200 phonebook status: number of phone numbers stored in memory / maximum
phone numbers storable in memory
STATUS REQUEST OF PRESETTING AND PERMITTED ACCESSES OF A NUMBER:
This command allows to know presetting (presetting of alarm and channel to be activated by phone call)
and permitted accesses (channels which can be activated by SMS) regarding one specic number stored
in memory.
numstatus 123456 3391234567
where:
numstatus command string
123456 access password
3391234567 telephone number to be added to the list
REPLY:
ALARM:ON/OFF,CALL:1/2/3/4,ch1:ON/OFF,ch2:ON/OFF,ch3:ON/OFF,ch4:ON/OFF
where:
ALLARM:ON/OFF notice of activated/deactivated alarm
CALL:1/2/3/4 number showing the channel which can be activated by phone call
ch1:ON/OFF activation status of channel 1 by SMS
ch2:ON/OFF activation status of channel 2 by SMS
ch3:ON/OFF activation status of channel 3 by SMS
ch4:ON/OFF activation status of channel 4 by SMS
READ LIST OF ENABLED PHONES:
This command permits to know the number of memorised phone numbers.
readbook 123456
where:
readbook command string
123456 access password
REPLY:
n°1;n°2;n°3;
8
To Next Page
Loading...
Need help?
General
