CONTROL PANEL CP.J4 ESA
WIRE DIAGRAM
Wire connections shown in Fig. 1 are described hereunder:
Terminals Function Description
L/N Power supply Input, 230VAC 50/60 Hz (L-Phase/N-Neutral)
L1/N1
Primary
Transformer
Connector for the connection of the primary transformer
L1: Line
N1: Neutral
0V/MOT/
AUX
Secondary
Transformer
Connector for the connection of the secondary transformer
0V: Input, 0V – MOT: 30 VAC - AUX: 18 VAC
M1 Motor Fast connector for the connection of the motor equipped with Encoder
BAR/BAR
SAFETY
EDGE
Input, safety edge. A 8.2 Kohm resistance is pre-installed on the terminals.
Safety edge of the resistive type, 8K2: connect the edge to the terminals by eliminat-
ing the pre-installed resistance, as shown in Figure 3.
Safety edge of the mechanical type: connect the edge in series to the resistance, as
shown in Figure 3.
When the safety edge is activated, the door movement is stopped and reversed for
around 3sec.
CLOSE CLOSE Input, CLOSE push-button (Normally Open contact).
OPEN OPEN
Input, OPEN push-button (Normally Open contact).
A timer/clock can be connected for openings according to timeframes.
PHOT Photocell Input, photocell is activated in the closing phase.
STOP STOP STOP button input (N.C. contact)
P.P. Step by step STEP BY STEP input ( N.O. contact)
+COM COMMON Common for all control inputs.
SHIELD/ANT antenna
Connection antenna to the built-in receiver
SHIELD: Screen / ANT: Signal
+ 24V - 24 Vac/dcs
Accessories power supply 24Vac/1A max.
Warning: With the backup battery card CB.24V, the output (without mains) is 24Vdc
(polarized).
Check devices connection polarity.
BLINK Flashing Connection to flashing light 24Vdc 15W max.
SCA AUX1
Normally open (N.O.), clean contact, which is configurable like SCA (open gate in-
dicator light) through parameter AUX1, second radio channel, courtesy or area light
(see Parameter AUX 1).
TECHNICAL DATA
Contol unit power supply
24 Vdc
Power supply
230 Vac 50/60 Hz or 115Vac 50/60Hz according to the version
Output
1 motor 24Vdc
Motor maximum power
220 W
Accessories power supply
24Vdc 1A max.
Protection level
IP40
Operating temp.
-20°C / +70°C
Radio receiver
built in 433,92 MHz confgurabile (rolling-code or programmable + rolling-code)
Memory capacity
64 rolling-code transmitters
To Next Page
Loading...
