Beninca DU.35V - EC Declaration of Conformity; General Safety Warnings

11
The product shall not be used for purposes or in ways other than
those for which the product is intended for and as described in
this manual. Incorrect uses can damage the product and cause
injuries and damages.
The company shall not be deemed responsible for the non-
compliance with a good manufacture technique of gates as well
as for any deformation, which might occur during use.
Keep this manual for further use.
Qualified personnel, in compliance with regulations in force, shall
install the system.
Packaging must be kept out of reach of children, as it can be
hazardous. For disposal, packaging must be divided the various
types of waste (e.g. carton board, polystyrene) in compliance
with regulations in force.
The installer must supply all information on the automatic, manual
and emergency operation of the automatic system and supply
the end user with instructions for use.
WARNING
•
An omnipolar switch/section switch with remo-
te contact opening equal to, or higher than 3mm
must be provided on the power supply mains..
Make sure that before wiring an adequate differential switch and
an overcurrent protection is provided.
Pursuant to safety regulations in force, some types of installation
require that the gate connection be earthed.
During installation, maintenance and repair, cut off power supply
before accessing to live parts.
Descriptions and figures in this manual are not binding. While
leaving the essential characteristics of the product unchanged,
the manufacturer reserves the right to modify the same under the
technical, design or commercial point of view without necessarily
update this manual.
EC Declaration of Conformity regarding machines
(Directive 98/37 CE, Annex II B) - No servicing
Manufacturer:Automatismi Benincà SpA.
Address:ViaCapitello,45-36066Sandrigo(VI)-Italia
Herewithdeclaresthat:theoperatorforhingedgatesmodelDU.35V.
• isintendedtobeincorporatedintoamachineorassembledtogetherwithotherdevicestoformamachineincompliancewiththe
ECDirective98/37,asamended;
• therefore,isnotineveryrespectcomplyingwiththisDirective;
• iscomplyingwithprovisionssetforthbythefollowingotherECDirective:
 ECLowvoltageDirective(73/23/EEC,93/68/EEC).
 ECDirectiveofElectromagneticCompatibility(89/336/EEC,93/68/EEC)
Moreover,weherewithdeclarethatthesystemshallnotbeputintoserviceuntilthemachineinwhichthesamewillbeincorporated
orofwhichitwillbecomeacomponent,isacknowledgedcompliantwiththeECDirective98/37andapplicablenationallegislation
andarelateddeclarationofconformityisdrawnup.Inotherwords,noservicingshallbecarriedoutuntilthesystemunderthis
declarationdoesnotformonesinglenalmachinewithothercomponents.
BenincàLuigi,Legalresponsible.
Sandrigo,08/04/2008.