Need help?Do you have a question about the Beninca DU.35V and is the answer not in the manual?
Shows standard wiring with opening limit switch interrupting motor phase.
Shows modified wiring for connecting opening limit switch to control unit.
Procedure for adjusting limit stops for opening, using a hex key and nut.
Steps to release the automatism for manual movement without electricity.
Notes regarding the separation of power cables from auxiliary cables.
Instructions for fixing the automatism's position relative to the ground.
Steps to fix the S bracket at the correct level for closing phase.
Steps for operating the gate manually in case of power cut or breakdown.
Checks for emergency release and safety devices, and periodic inspection.
Shows standard wiring with opening limit switch interrupting motor phase.
Shows modified wiring for connecting opening limit switch to control unit.
Procedure for adjusting limit stops for opening, using a hex key and nut.
Steps to release the automatism for manual movement without electricity.
Notes regarding the separation of power cables from auxiliary cables.
Instructions for fixing the automatism's position relative to the ground.
Steps to fix the S bracket at the correct level for closing phase.
Steps for operating the gate manually in case of power cut or breakdown.
Checks for emergency release and safety devices, and periodic inspection.
General| Motor voltage | 24 Vdc |
|---|---|
| Max leaf length | 3.5 m |
| Encoder | Yes |
| Irreversible | Yes |
| Operating temperature | -20°C / +50°C |
| Maximum Torque | 35 Nm |
To Next Page
