25
KMB24
USER GUIDE
KEEP THIS GUIDE AND MAKE IT AVAILABLE TO ALL USERS OF THE AUTOMATION.
SAFETY STANDARDS
WARNING: Important safety instructions. It is important for the safety of persons to follow these instructions. Save these
instructions.
Do not stand in the movement area of the door.
Do not allow children to play with the commands or in proximity of the leaves.
Children should be supervised to ensure that they not play with appliance.
Do not allow children to play with fixed controls. Keep remote controls away from children;
In the case of functioning anomalies do not attempt to repair the fault but contact a BENINCÀ specialised technician.
MANUAL MOVEMENT FROM INSIDE
To manually open or close the door in case of power failure or faults, two solutions are possible:
• Built-in release
Introduce the customized key C, turn it clockwise and pull lever L. At this point the geared motor is released and the gate canbe
manually pushed.
To reset the normal operation, close lever L again and turn key C anticlockwise. Manually move the gate until the geared motor
is engaged again.
• Rope external release: optional
It is available for fitting to external wall or with accessory to be mounted flush (see MB.SE).
MAINTENANCE
• Periodically check the efficiency of the manual emergency release.
• The actuator does not require routine maintenance, however it is necessary to periodically check the safety devices and the other
parts of the plant that could create dangers following wear.
• Frequently examine the installation for imbalance and signs of wear or damage to cables, springs and mounting. Do not use if
repair or adjustment is necessary.
• Disconnect the supply when cleaning or other maintenance is being carried out, if the appliance is automatically controlled.
• Take good care of the maintenance book that the installer must supply you and make sure you respect the required maintenance
program.
• Check the efficiency of photocells at least every 6 months.
DISPOSAL
Whenever the product is put out of service, the legislative provisions in force must be followed regarding differentiated di-
sposal and re-cycling of the various components (metals, plastics, electric cables, etc.). It is advised to contact a BENINCÀ
specialised technician or a specialised company that is enabled for this purpose.
C
L
To Next Page
Loading...
