4
GENERAL RECOMMENDATIONS
Automatismi Benincà SpA is not liable for damage caused by improper use or by incorrect installation of products or components.
WARNING: Important safety instructions. Follow all instructions since incorrect installation can lead to severe injury.
If this is the first time you realise an automation for swing gates with KMB24, we recommend that you read this manual carefully as
it contains important advice and information for the realisation of the plant in safe conditions.
Keep the various components on hand to gain confidence with them while reading this manual.
Keep this manual for future use
Attention!
Potentially dangerous operations. Scrupulously respect the indications given.
Useful indication.
Suggestions and recommendations for simplifying and/or improving the installation operations.
The automation of a door cannot be considered the only device for protection against intrusion.
Do not use any of the components in unsuitable environments (salty, acid or potentially explosive atmosphere)
All operations that require the protection shells of the devices opened, must take place without mains power supply.
Check that the temperature range marked on the drive is suitable for the location.
The drive cannot be used with a driven part incorporating a wicket door (unless the drive cannot be operated with the wicket door
open).
Ensure that entrapment between the driven part and the surrounding fixed parts due to the opening movement of the driven part is
avoided.
After installation, ensure that the mechanism is properly adjusted and that the protection system and any manual release function
correctly.
PRODUCT DESCRIPTION
DESTINATION OF USE
This product is destined exclusively for the opening and closure of swing doors for residential use, characterised by dimensional
limits and weight as indicated in this manual in the “Limits of use” paragraph”.
No other use is allowed.
BENINCÀ is not liable for uses that are not in compliance with those indicated in these instructions.
The kit is made up from two electromechanical operators with 24Vdc motor (LOW VOLTAGE), which allows movement of the leaves
via an articulated anti-shearing arm. The irreversible electromechanical gear motori keeps the gate locked in the closing and opening
positions.
Functioning is controlled by and electronic control unit, installed in one of the two operators.
The control unit commands the movement of the two motors and the functioning of the various accessories.
PRELIMINARY CHECKS
Before installation it is indispensable to perform several checks:
• Check the solidity of the structure installed in relation to the forces generated by the motor. Attach the motor stably using adguate
materials.
• The pillars supporting the leaves must be suitable for fixing the gear motors.
• If avialable, check the contenent of the EC declaration of conformity of the manual gate.
• If necessary, carry out the structural calculation and attach it to the technical file.
• Carry out the analysis of the risk and choice of solutions in accordance with the Machinery Directive 2006/42/CE and the standards
EN 13241-1, EN 12453, EN 12445.
Referer to Fig.4:
A - Impact and crushing of the main closing edge.
B - Impact and crushing in the area of opening.
C - Impact in the area of closure.
the KMB24 has been built to guarantee the PL c (Performance Level c), category 2, according to the EN 13849-1 standard(Safety
of Machinery).
• Try and open the gate manually, the leaves must move without effort and without points of resistance for the entire run.
• When left in any intermediate position the leaf must not move.
• The hinges and components subject to wear must be in perfect working condition. If this is not the case, replace the faulty parts.
• With the gate completely closed, check that the leaves are aligned perfectly along their entire length.
• The presence of a opening and closing stop is indispensable (Fig.3 ref. 5 and 8). It mist be installed if not present.
The reliability and safety of the automation depend on the state of the gate structure.
Check that there is enough space for installation of the operator in safe and comfortable conditions.
To Next Page
Loading...
