Bennett Read MULTI-FORCE User Manual

9
MAINTENANCE AND CARE
CLEANING THE POST-MOTOR
MICROPARTICLE FILTER
THE POST-MOTOR FILTER ASSISTS IN THE
FILTRATION PROCESS TO RETURN CLEANER
AIR INTO THE ROOM
1. Unplug the vacuum from the electrical
outlet
2. Remove the filter door (17) (located at
the back of the vacuum) by
pressing the tab down. Take care when
removing the filter door
3. Remove the post-motor filter from
the filter door
4. The post-motor filter can be hand
washed in cold water with a mild
detergent. Rinse well and air dry
COMPLETELY before placing back
into the vacuum
5. Replace the post-motor filter into the
filter door. Then replace the assembly
into the machine by placing the two
tabs on the bottom of the filter door into
the notches on the bottom of the
post-motor filter compartment and push
into the vacuum until it clicks into place.
Ensure that the tabs are properly
inserted into the housing
Never operate your MULTI-FORCE
vacuum with damp or wet lters, or
without all lters in place.
!
WARNING:
This product is intended for household use only
and not for commercial or industrial use.
Vacuuming of dust from products like plaster,
concrete or ashes will damage the motor and
void the guarantee.
NOTICE:
2.
For maximum cleaning performance check the
filters often and clean or replace them regularly.
TIP:
3.

Bennett Read MULTI-FORCE Specifications

General

Brand	Bennett Read
Model	MULTI-FORCE
Category	Vacuum Cleaner
Language	English