14
When attaching the tool, do not press on the securing
tabs. Gently press in line with tabs on the body of the tool.
There are arrows that indicate where to press.
NOTE:
To remove the hard floor tool, unclip from
the attachment by placing your thumb
beneath the tabs and lifting
14
YOU ARE NOW READY TO SUCK UP THAT WET SPILL!
Grasp the plug (11) at the rear of the machine and pull power cable to its full extent (See warnings).
DO NOT extend power cable beyond red warning line on power cable. Insert Plug into the main power
supply. Your BENNETT READ ONE is equipped with an automatic cord rewind function. After unplugging
the machine from the wall socket, give the power cable a short sharp tug and then let the automatic cord
rewind slowly retract the power cable
Press power on button (1). If machine
is on, the LED light on the switch will
be illuminated
15
The pump switch must NOT be used in any vacuuming mode. Using the pump without water
will lead to PUMP FAILURE. Only switch the pump on when using your BENNETT READ
ONE for deep cleaning purposes.
IMPORTANT:
16
17
Pull cleaning head towards you across wet spill, making sure that the cleaning head is in a slightly raised position so as
to keep the suction head in contact with the hard floor
Removing a wet spill on a carpet follows the same procedure without attaching the hard floor tool
To Next Page
Loading...
Need help?
General
