6
DRY VACUUMING:
Your Bennett Read Stealth Vacuum is perfect for vacuuming a variety of surfaces including
carpets, tiles, mattresses, upholstery, curtains, car upholstery etc.
Setting up your Bennett Read Stealth for vacuuming:
1. Remove the Motor Unit (5) from the Dirt Tank (6) by pulling the Securing Clips (4) outwards
2. Ensure that the Microparticle dust bag and Dome Filter are securely installed in place as
shown below:
5. Insert large end (opposite end to handle) of the Flex Hose (3) into Vacuum Function Hose
Port (2) until you hear a “click”
6. Attach the Metal Extension Wand (15) to the free end of Flex Hose Handle
7. Attach your choice of cleaning head (14)/ (11)/ (12), to the free end of the Extension Wand
8. Plug the Power Cable into the wall socket. Take care not to pull the Power Cable beyond
the yellow and red markers at the end of the cord as shown below
9. To retract the Power Cord, press down on the Automatic Cord Rewind Button (7) until the
cord has completly retracted
10. Switch on the unit by pressing down on the Power Switch (1). An LED light above the
Power Switch will indicate when the machine is plugged in and ready for use
4. Replace Motor Unit (5) and close Securing Clips (4)
by pushing inwards as shown on the right:
3. Ensure that the Premotor Foam Filter is installed as shown below:
TIP: Vacuum in different directions across your surfaces to give you best results
To Next Page
Loading...
