10/ 2019
BENNING CM 9-2
8
Operating manual
BENNING CM 9-2
TRUERMSleakagecurrentclampaccordingtoEN61557-13for
- measuringtheleakagecurrents(dierentialcurrentandprotectivecon-
ductorcurrent)inelectricalsystemsanddevices
- AC current measurements
Table of contents
1. User instructions
2. Safety instructions
3. Scope of delivery
4. Device description
5. General information
6. Ambient conditions
7. Electrical specifications
8. Measuring with the BENNING CM 9-2
9. Maintenance
10. Environmental note
1. User instructions
Thisoperatingmanualisintendedfor
- skilledelectriciansand
- electrotechnicallytrainedpersonnel.
TheBENNING CM9-2is intendedfor making measurementsin dryenviron-
ment.Itmustnotbeusedinpowercircuitswithanominalvoltagehigherthan
CATIV300VorCATIII600V(MoredetailsinSection6.“Ambientconditions”).
ThefollowingsymbolsareusedinthisoperatingmanualandontheBENNING
CM9-2:
ApplicationaroundandremovalfromHAZARDOUSLIVEconductors
ispermitted.
Warningofelectricaldanger!
Indicatesinstructionswhichmustbefollowedtoavoiddangertoper-
sons.
Attention!Mustcomplywithdocumentation!
Thissymbolindicatesthattheinformationprovidedintheoperating
manualmustbecompliedwithinordertoavoidrisks.
CAT III
MeasuringcategoryIIIisapplicabletotestingandmeasuringcircuits
connectedtothedistributioncircuitofthelow-voltagemainsinstalla-
tionofabuilding.
CAT IV
MeasuringcategoryIVisapplicabletotestingandmeasuringcircuits
connected tothe feed-in point of thelow-voltage mains installation
ofabuilding.
Donotusethedeviceinexternallow-frequencymagneticeldswith
morethan30A/m.
ThissymbolontheBENNINGCM9-2 indicatesthattheBENNING
CM9-2isequippedwithprotectiveinsulation(protectionclassII).
Please observe the operating manual!
Thissymbolappearsonthedisplaytoindicateadischargedbattery.
(AC)Alternatingcurrent
Ground(voltageagainstground)