Benning CM 9-2 - Device Description; Safety Instructions; Scope of Delivery

10/ 2019 BENNING CM 9-2
9

2. Safety instructions
Theinstrumentisbuiltandtestedinaccordancewith
DINVDE0411Part1/EN61010-1
DINVDE0411Part2-032/EN61010-2-032
DINVDE0413Part13/EN61557-13
andhasleftthefactoryinperfectlysafetechnicalcondition.
Topreservethisconditionandtoensuresafeoperationofthedevice,theuser
mustobservethe notes andwarnings giveninthese instructionsatall times.
Improperhandling andnon-observance ofthewarnings mightinvolve severe
injuries or danger to life.

WARNING! Be extremely careful when working with bare con-
ductors or main line carrier! Contact with live conductors will
cause an electric shock!

The BENNING CM 9-2 must be used in electrical circuits of over-
voltage category III with a conductor for a maximum of 600 V
to earth or of overvoltage category IV with a conductor for a
maximum of 300 V to earth only.
Please observe that work on live parts and electrical compo-
nents of all kinds is dangerous! Even low voltages of 30 V AC
and 60 V DC may be dangerous to human life!

Before starting the current clamp multimeter, always check the
device as well as all measuring leads for damages.
Ifitcanbeassumedthatsafeoperationisnolongerpossible,switchthedevice
o󰀨immediatelyandsecureitagainstunintendedoperation.
Safeoperationcanbeassumedtobenolongerpossible,if
- thedeviceexhibitvisibledamages,
- thedevicenolongerworks,
- thedevicehasbeenstoredunderunfavourableconditionsforalongerpe-
riodoftime,
- thedevicewasexposedtoextraordinarystressduringtransport,or
- ifthedeviceisexposedtomoisture.

Maintenance:
Do not open the multimeter, because it contains no components
which can be repaired by the user. Repair and service must be
carried out by qualified personnel only!

Cleaning:
Regularly wipe the housing by means of a dry cloth and clean-
ing agent. Do not use any polishing agents or solvents!
3. Scope of delivery
ThescopeofdeliveryoftheBENNINGCM9-2comprises:
 3.1 OneBENNINGCM9-2
 3.2 Onecompactprotectivepouch
 3.3 Two1.5Vmignonbatteries(IECLR6/AA)
 3.4 Oneoperatingmanual
Partssubjecttowear:
- TheBENNINGCM9-2issuppliedbymeansoftwointegrated1.5Vmignon
batteries(IECLR6/AA).
4. Device description
Seegure1: Appliancefrontface
Thedisplayandoperatingelementsshowningure1aredesignatedasfollows:
1
Measuring clamp,forclampingliveconductors
2
Prong guard,protectsuserfromaccidentalcontactwithconductor
3
Opening lever,foropeningandclosingthecurrentprongs
4
Bluetooth
®
key for enabling the Bluetooth
®
interface/measuring point illumi-
nation(2s)
5
LPF key,enablesthelow-pass filter (50Hzto60 Hz)orthedevice filter
(1kHz)incompliancewithEN61557-16
6
Digital display,fordisplayingthemeasuredvalueandrangeexceedance
7
LED measuring point illumination