18 Positioning your projector
Adjusting the projected image
Adjusting the projection angle
If the projector is not placed on a flat surface or
the screen and the projector are not
perpendicular to each other, the projected
image becomes trapezoidal. You can screw the
adjuster feet to fine-tune the horizontal angle.
To retract the feet, screw the adjuster feet in a
reverse direction.
Fine-tuning the image size and clarity
Adjusting the focus
Adjust the focus of the image in one of the following situations:
• During initial setup
• After moving the projector
• After adjusting zoom
• When image is fuzzy and you wish to obtain a clearer image
To adjust the focus:
1. Press FOCUS on the remote control.
2. Press and hold / to adjust the focus.
3. Press OK to save and exit.
Do not look into the lens while the light source is on. The strong light from the light source may cause
damage to your eyes.
To Next Page
