48 Menu operation
Operation
Settings
• LED Indicator
You can turn off the LED warning lights. This is to avoid any light
disturbance when viewing images in a dark room.
• Power On/Off Settings
• Direct Power On: Allows the projector to turn on automatically once
the power is fed through the power cord.
• Signal Power On: Sets whether to turn the projector directly on
without pressing POWER or ON when the projector is in
standby mode and detects a HDMI or Type C signal.
• Auto Power Off: Allows the projector to turn off automatically if no
input signal is detected after a set period of time to prevent
unnecessary waste of light source life.
Security Settings
• Panel Key Lock
With the control keys on the projector and remote control locked, you can
prevent your projector settings from being changed accidentally (by
children, for example). When the Panel Key Lock is on, no control keys on
the projector and remote control will operate except POWER.
To release panel key lock, press and hold (the right key) on the projector
or remote control for 3 seconds.
If you turn off the projector without disabling panel key lock, the projector will still be in
locked status the next time it is turned on.
• Password/Power On Lock
See Utilizing the password function on page 28.
Factory Default
Returns all settings to the factory preset values.
The following settings will still remain: 2D Keystone, Digital Shrink & Shift, Blanking,
Corner Fit, Projector Position, Light Usage Time, Security Settings, Baud Rate, High
Altitude Mode, HDMI Equalizer.
Reset System
Returns all the settings on the System main menu to the factory default
values.
The following settings will still remain: Light Source Information, Security Settings.
To Next Page
