32 Menu operation
SYSTEM SETUP: BASIC menu
12V Trigger
There is one 12V trigger that works independently according to your needs for
installation scenarios.
• Off: If this is selected, the projector will not send electronic signal out when it
is turned on.
• On: The projector will send a low to high electronic signal out when it is
turned on, a high to low signal out when it is turned off.
LED Indicator
Selects to turn off the LED warning lights. This is to avoid any light disturbance
when viewing images in a dark room.
High Altitude
Mode
We recommend you turn on the High Altitude Mode when your environment is
between 1500 m –3000 m above sea level, and ambient temperature is between
0°C–30°C.
You can also select Auto, allowing the projector to automatically detect the
altitude and display reminder message suggesting you to adjust the setting when
necessary.
Operation under "High Altitude Mode" may cause a higher decibel operating
noise level because of increased fan speed necessary to improve overall system
cooling and performance.
If you use this projector under other extreme conditions excluding the above, it
may display auto shut-down symptoms, which is designed to protect your projector
from over-heating. In cases like this, you should switch to High Altitude mode to
solve these symptoms. However, this is not to state that this projector can operate
under any and all harsh or extreme conditions.
Keystone See Correcting keystone on page 18.
Projector ID
Settings
Sets the projector ID for this projector (between 01~99). When multiple adjacent
projectors are in operation at the same time, switching the projector ID codes can
prevent interference from other remote controls. After the Projector ID is set,
switch to the same ID for the remote control to control this projector. See Remote
control on page 10
Set the ID
1. Press and hold ID SET until the ID setting indicator lights up.
2. Enter the ID for the remote control (between 01~99). The remote control ID
should be the same as the corresponding projector ID.
3. The ID is saved successfully when you see the ID setting indicator starts
flickering and then blackout.
Clear the ID
1. Press and hold ID SET until the ID setting indicator lights up.
2. Press ALL to clear current ID setting of the remote control.
3. The ID is cleared successfully when you see the ID setting indicator starts
flickering and then blackout.
Language Sets the language for the On-Screen Display (OSD) menus.
To Next Page
