Operation 41
Controlling the projector remotely through a web browser
Once you have the correct IP address for the projector and the projector is on or in standby
mode, you can use any computer that is on the same local area network to control the
projector.
1. Enter the address of the projector in the address bar of your browser and click GO.
2. The remote network operation page opens. This page allows you to operate the
projector as if you were using the remote control or control panel on the projector.
i. These buttons function the same as the ones on the OSD menus or remote
control. See "2. PICTURE menu" on page 48 and "Remote control" on page 11 for
details.
ii. To switch input source, click on your desired signal.
• The Menu button can also be used to go back to previous OSD menu, exit and save menu
settings.
• The source list varies according to the connectors available on the projector. “HDMI 1”
stands for the HDMI signal; “Video 1” stands for the Video signal; “S-Video 1” stands for
the S-Video signal.
• The software is available in multiple languages: English, French, German, Italian, Spanish,
Traditional Chinese, Simplified Chinese, and Japanese. It will display the language of your
computer operating system (OS) when connected to the projector. If the language of your
OS is not available, it will display the English version.
i
i
i
ii
To Next Page
Loading...
