Operation48
Function Description
Picture Mode
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See "Selecting a
picture mode" on page 32 for details.
Reference
Mode
Selects a picture mode that best suits your need for the image quality
and further fine-tune the image based on the selections listed on the
same page below. See "Setting the User 1/User 2 mode" on page 32 for
details.
Brightness
Adjusts the brightness of the image. See "Adjusting Brightness" on page
33 for details.
Contrast
Adjusts the degree of difference between dark and light in the image. See
"Adjusting Contrast" on page 33 for details.
Color
Adjusts the color saturation level -- the amount of each color in a video
image. See "Adjusting Color" on page 33 for details.
This function is only available when a Video, S-Video or
Component Video signal is selected and the system format is
NTSC or PAL.
Tint
Adjusts the red and green color tones of the image. See "Adjusting Tint"
on page 33 for details.
This function is only available when a Video or S-Video signal is
selected and the system format is NTSC.
Sharpness
Adjusts the image to make it look sharper or softer. See "Adjusting
Sharpness" on page 33 for details.
This function is only available when a Video, S-Video or
Component Video signal is selected and the system format is
NTSC or PAL.
Brilliant Color
See "Adjusting Brilliant Color" on page 34 for details.
Color
Temperature
There are four color temperature settings available. See "Selecting a
color temperature" on page 34 for details.
3D Color
Management
See "3D Color Management" on page 34 for details.
Save Settings
Saves the settings made for User 1 or User 2 mode.
Quick Auto
Search
See "Switching input signal" on page 29 for details.
Color Space
Conversion
See "Changing Color Space" on page 29 for details.
2. PICTURE menu
3. SOURCE menu
To Next Page
Loading...
