How to fix BenQ Projector that does not turn on?
If your BenQ Projector doesn't turn on, first ensure the power cord is securely plugged into both the projector's AC power jack and a working power outlet, checking that the outlet switch is on. Also, if the projector is cooling down, wait for the process to complete before attempting to power it on again.
Why does not BenQ MS616ST remote control work?
If the remote control for your BenQ Projector isn't working, try the following: * Replace the battery with new ones. * Remove any obstacles between the remote control and the projector. * Ensure you are within 8 meters (26 feet) of the projector.
What to do if my BenQ MS616ST has no picture?
If you have no picture on your BenQ Projector, make sure the video source is turned on and correctly connected. Check the connection between the projector and the input signal device. Select the correct input signal using the SOURCE key on the projector or remote control. Finally, ensure the lens cover is open.
How to fix blurred image on BenQ MS616ST?
If you're experiencing a blurred image with your BenQ Projector, try these steps: 1. Adjust the focus of the lens using the focus ring. 2. Adjust the projection angle, direction, and height of the projector to properly align it with the screen. 3. Ensure the lens cover is open.
General| Contrast Ratio | 13000:1 |
|---|---|
| Weight | 2.6 kg |
| Display Technology | DLP |
| Keystone Correction | Vertical: ±40 degrees |
| Throw Ratio | 0.9 ~ 1.08 (78"@1M) |
| Zoom Ratio | 1.2x |
| Aspect Ratio | 4:3 |
| Input Terminals | HDMI, VGA, Composite Video, Audio |
Provides crucial safety guidelines for operating the projector, including reading the manual and avoiding eye damage.
Addresses safety regarding physical impact, liquids, ceiling mounting, and grounding.
Explains the functions of the projector's control panel buttons and indicator lights.
Details the functions of each button on the projector's remote control.
Describes four possible installation locations: Front Table, Front Ceiling, Rear Ceiling, and Rear Table.
Provides a chart and explanation for calculating projection distance based on screen size.
Outlines the steps and considerations for connecting various devices to the projector.
Compares video input methods (HDMI, Component, S-Video, Video) for picture quality.
Step-by-step guide for powering on the projector and initial setup.
Details how to adjust projection angle, height, and auto-adjust image settings.
Describes how to manually correct image distortion (keystoning) using the remote or OSD menu.
Explains how to select different input sources connected to the projector.
Details on adjusting Brightness, Contrast, Color, Tint, Sharpness, and Brilliant Color.
Step-by-step instructions for properly powering off the projector and its cooling process.
Explains how to use the zoom and focus rings for optimal image size and sharpness.
General advice on keeping the projector lens and case clean.
Step-by-step instructions for cleaning the projector lens safely.
How to check the equivalent lamp hour and extend lamp life using mode settings.
Information on lamp warning indicators and messages prompting lamp replacement.
Detailed, step-by-step instructions for safely replacing the projector lamp.
Continues the lamp replacement procedure, covering securing the new lamp and cover.
Instructions on how to reset the lamp timer after replacing the lamp.
Tips for extending the projector lamp's lifespan through mode settings and auto power off.
Lists causes and remedies for the projector failing to power on.
Troubleshooting steps for when no image is displayed on the screen.
To Next Page
