What to do if BenQ MW853UST+ Projector remote control does not work?
If the BenQ Projector's remote control isn't working, first, replace the battery with a new one. If that doesn't solve the issue, check for any obstructions between the remote and the projector and remove them. Finally, make sure you are within 7 meters (23 feet) of the projector.
Why is there no picture on my BenQ MW853UST+?
If there is no picture on your BenQ Projector, ensure that the video source is turned on and correctly connected. Also, verify that the projector is correctly connected to the input signal device by checking the connection. Finally, make sure the correct input signal is selected using the SOURCE key on the projector or remote control.
How to fix BenQ MW853UST+ Projector that does not turn on?
If your BenQ Projector doesn't turn on, first, ensure the power cord is securely plugged into both the AC inlet on the projector and the power outlet, and that the outlet switch is on. Also, if you've recently tried turning it on, wait until the cooling down process has completed before attempting to power it on again.
How to fix blurred image on BenQ MW853UST+ Projector?
If the image on your BenQ Projector is blurred, adjust the focus of the lens using the focus ring. If the issue persists, adjust the projection angle, direction, and height of the unit to properly align the projector and the screen.
General| Lamp Life (Normal) | 4000 hours |
|---|---|
| Lamp Life (Economic) | 10000 hours |
| Display Technology | DLP |
| Zoom Ratio | 1.2x |
| Input Lag | 16 ms |
| 3D Ready | Yes |
| Warranty | 3 years |
| Resolution | 1280 x 800 |
| Connectivity | HDMI, VGA, USB, RS-232 |
| Aspect Ratio | 16:10 |
| Noise Level (Economic Mode) | 28 dB |
| Keystone Correction | Vertical ± 30° |
| Projection Method | Front, Rear, Ceiling, Table |
To Next Page
