Operation 43
Turning off the Power on/off ring tone
To turn off the ring tone:
1. Repeat steps 1-2 in Muting the sound section.
2. Highlight Power on/off Ring Tone and select Off.
The only way to change Power on/off ring tone is setting On or Off here. Setting the sound mute
or changing the sound level will not affect the Power on/off ring tone.
Adjusting the microphone’s sound level
1. Repeat steps 1-2 in Muting the sound section.
2. Highlight Microphone Volume and select a desired sound level.
Microphone sound will still function even though Mute is activated.
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
• Menu display Time in the SYSTEM SETUP: Basic > Menu Settings menu sets
the length of time the OSD will remain active after your last key press. The time length
ranges from 5 to 30 seconds in 5-second increments. Use / to select a suitable
time frame.
• Menu Position in the SYSTEM SETUP: Basic > Menu Settings menu sets the
OSD position in five locations. Use / to select a preferred position.
• Reminder Message in the SYSTEM SETUP: Basic > Menu Settings menu sets
whether to display reminder messages on screen. Use / to select your desired
setting.
• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the
OSD menus. Use Enter to select your language.
Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be
displayed during projector start-up. Use / to select a screen.
To Next Page
Loading...
