BenQ MX854UST - Setup and Installation; Shipping and Accessories

8
Command table
• Available features differ by projector specification, input sources, settings, etc..
• Commands are working if the standby power is 0.5W or a supported baud rate of the projector is set.
• Uppercase, lowercase, and a mixture of both types of characters are accepted for a command.
• If a command format is illegal, it will echo Illegal format.
• If a command with correct format is not valid for the projector model, it will echo Unsupported item.
• If a command with correct format cannot be executed under certain condition, it will echo Block item.
• If RS232 control is performed via LAN, a command works whether it starts and ends with <CR>. All the commands and
behaviors are identical with the control through a serial port.
Function
Type
Operation
ASCII
Support
Power
Write
Power On
<CR>*pow=on#<CR>
Yes
Write
Power off
<CR>*pow=off#<CR>
Yes
Read
Power Status
<CR>*pow=?#<CR>
Yes
Source Selection
Write
COMPUTER/YPbPr
<CR>*sour=RGB#<CR>
Yes
Write
COMPUTER 2/YPbPr2
<CR>*sour=RGB2#<CR>
Yes
Write
Component
<CR>*sour=ypbr#<CR>
No
Write
Component2
<CR>*sour=ypbr2#<CR>
No
Write
DVI-A
<CR>*sour=dviA#<CR>
No
Write
DVI-D
<CR>*sour=dvid#<CR>
No
Write
HDMI
<CR>*sour=hdmi#<CR>
Yes
Write
HDMI 2
<CR>*sour=hdmi2#<CR>
Yes
Write
Composite
<CR>*sour=vid#<CR>
Yes
Write
S-Video
<CR>*sour=svid#<CR>
Yes
Write
Network
<CR>*sour=network#<CR>
No
Write
USB Display
<CR>*sour=usbdisplay#<CR>
No
Write
USB Reader
<CR>*sour=usbreader#<CR>
No
Read
Current source
<CR>*sour=?#<CR>
Yes
Audio Control
Write
Mute On
<CR>*mute=on#<CR>
Yes
Write
Mute Off
<CR>*mute=off#<CR>
Yes
Read
Mute Status
<CR>*mute=?#<CR>
Yes
Write
Volume +
<CR>*vol=+#<CR>
Yes
Write
Volume -
<CR>*vol=-#<CR>
Yes
Read
Volume Status
<CR>*vol=?#<CR>
Yes
Write
Mic. Volume +
<CR>*micvol=+#<CR>
No
Write
Mic. Volume -
<CR>*micvol=-#<CR>
No
Read
Mic. Volume Status
<CR>*micvol=?#<CR>
No
Audio source
select
Write
Audio pass Through off
<CR>*audiosour=off#<CR>
Yes
Write
Audio-Computer1
<CR>*audiosour=RGB#<CR>
Yes