English
2
Notice
Cooling notice
y
Ventilation
Air inlet
Air outlet
y
Caution for installation
For proper ventilation of the projector, make sure to leave some space around the projector as
shown in the illustration below:
• Table
50cm
above
50cm
above
70cm above
• Ceiling • Stacking
30cm above
Minimum 100mm
When edge blending
• To avoid the image shaking or some pixels in the display may be misaligned, do not use the
projector in the following location:
• In a building close to a construction site.
• In a room where an air conditioner unit is working and it vibrates.
• In a place where the temperature changes dramatically that may cause thermal contraction.
• Before making any adjustment, leave the projector lit for at least 15 minutes after its light source
is turned on. This allows the internal temperature of the projector to stabilize.
To Next Page
Loading...
