Why won't my BenQ Projector turn on?
If your BenQ Projector doesn't turn on, there could be several reasons. First, ensure the power cable is properly plugged into both the projector's AC inlet and the power outlet, and that the power outlet switch is on. Second, if you've recently turned it off, wait until the cooling down process has completed before attempting to turn it on again. Finally, check that the lamp cover is securely attached.
How to fix a BenQ Projector remote control that is not working?
If the remote control for your BenQ Projector isn't working correctly, try these steps: First, replace both batteries with new ones. Second, make sure there are no obstacles between the remote control and the projector. Finally, ensure you are within 8 meters (26.2 feet) of the projector.
How to fix a blurred picture on a BenQ Projector?
If the picture on your BenQ Projector is blurred, try the following: Adjust the focus of the lens using the focus ring. Also, adjust the projection angle and direction as well as the height of the projector to ensure the projector and the screen are aligned properly.
Why is the image unstable on my BenQ W750?
If the image on your BenQ Projector is unstable, it might be due to loose connection cables. Ensure that the connection cables are securely connected to both the projector and the signal source at the appropriate terminals.
What to do if my BenQ W750 Projector has no picture?
If your BenQ Projector is showing no picture, there might be a few reasons. First, ensure that the video source is turned on and the signal cable is correctly connected. Second, verify that the projector is correctly connected to the input source device. Finally, make sure you've selected the correct input source using the Source keys on the remote or the SOURCE button on the projector.
What to do if 3D content does not display correctly on BenQ W750 Projector?
If 3D content is not displaying correctly on your BenQ Projector, consider these potential causes: Ensure that the 3D glasses are charged. Verify that the settings in the 3D menu are correctly configured. Confirm that you are using a 3D Blu-ray Disc. Also, check that the correct input source has been selected using the Source keys on the remote or the SOURCE button on the projector.
General| Display Technology | DLP |
|---|---|
| Brightness | 3000 ANSI Lumens |
| Contrast Ratio | 13000:1 |
| Lamp Life (Normal) | 4000 hours |
| Lamp Life (Eco) | 6000 hours |
| Lamp Life (SmartEco) | 6500 hours |
| 3D Compatibility | Yes |
| Speaker | 10W |
| Weight | 2.6 kg |
| Projection Size | 30" - 300" |
| Aspect Ratio | 16:10 (5 aspect ratio selectable) |
| Color Wheel | 6-Segment |
| Input Terminals | HDMI, VGA, Composite Video, USB |
| Output Terminals | Audio Out |
| Native Resolution | 1280 x 800 (WXGA) |
To Next Page
