Benson equipment must be installed and maintained in accordance with the relevant provisions of the Gas
Safety (Installations and Use) Regulations 1998 for gas red products. Due account should also be taken of
any obligations arising from the Health and Safety at Works Act 1974 or relevant codes of practice. In addition
the installation must be carried out in accordance with the current IEE wiring regulations (BS 7671),
BS 6896 (Industrial & Commercial) and any other relevant British Standards and Codes of Practice
by a qualied installer. All external wiring MUST comply with the current IEE wiring regulations.
Benson Gas Fired
Cabinet Heaters
installation and operatinG Manual
Part No. 20-45-159
INDEX Section
Introduction and Document Index
Installation Requirements ................................................................................. 1
Installation Instructions ................................................................................. 2
Commissioning Instructions ................................................................................. 3
Servicing Instructions ............................................................................................... 4
Spare Parts ............................................................................................... 5
Fault Finding Guide ............................................................................................... 6
Replacing Parts ............................................................................................... 7
User and Operating Instructions .................................................................... 8
WARNINGS
To Next Page
Need help?
General
