BENSON 180 - User Manual

BENS O N
Benson equipment must be installed and maintained in accordance with the relevant provisions of the Gas
Safety (Installations and Use) Regulations 1998 for gas red products. Due account should also be taken of
any obligations arising from the Health and Safety at Works Act 1974 or relevant codes of practice. In addition
the installation must be carried out in accordance with the current IEE wiring regulations (BS 7671),
BS 6896 (Industrial & Commercial) and any other relevant British Standards and Codes of Practice
by a qualied installer. All external wiring MUST comply with the current IEE wiring regulations.
Benson Gas Fired
Cabinet Heaters
installation and operatinG Manual
Part No. 20-45-159
INDEX Section
Introduction and Document Index
Installation Requirements ................................................................................. 1
Installation Instructions ................................................................................. 2
Commissioning Instructions ................................................................................. 3
Servicing Instructions ............................................................................................... 4
Spare Parts ............................................................................................... 5
Fault Finding Guide ............................................................................................... 6
Replacing Parts ............................................................................................... 7
User and Operating Instructions .................................................................... 8
WARNINGS

Summary

Installation Requirements

Health and Safety

Essential safety regulations, PPE, and precautions for installation.

Location and Positioning

Electrical Supply Requirements

Guidelines for connecting the main electrical supply, isolation, and wiring.

Flue System

Installation Instructions

Flue Installation

Gas Installation and Connection

Procedures for connecting the gas supply, including safety checks.

Electrical Installation and Connection

Instructions for wiring, earthing, and connecting the electrical supply.

Commissioning Instructions

Commissioning - Pretest

Pre-installation checks to ensure safety, gas, and electrical integrity.

Commissioning - Ignition

Steps for enabling the burner and verifying the ignition sequence.

Commissioning - Hand Over

Fault Finding Guide

Burner Fails to Run

Troubleshooting steps for when the burner does not start or operate.

Fan Starts, Burner Locks Out

Diagnosing issues when the fan runs but the burner enters a lockout state.

Burner Lights, Fails Main Flame

Steps to resolve issues where the burner ignites but fails to establish a stable flame.

Burner Shuts Down on Overheat

Identifying causes and solutions for the burner shutting down due to overheating.

Replacing Parts

Burner Replacement

Step-by-step instructions for removing and replacing the burner unit.

Controller Replacement

BENSON 180 Specifications

General

Brand	BENSON
Model	180
Category	Gas Heater
Language	English