BENSON 300 - User Manual

BENS O N
Benson equipment must be installed and maintained in accordance with the relevant provisions of the Gas
Safety (Installations and Use) Regulations 1998 for gas red products. Due account should also be taken of
any obligations arising from the Health and Safety at Works Act 1974 or relevant codes of practice. In addition
the installation must be carried out in accordance with the current IEE wiring regulations (BS 7671),
BS 6896 (Industrial & Commercial) and any other relevant British Standards and Codes of Practice
by a qualied installer. All external wiring MUST comply with the current IEE wiring regulations.
Benson Gas Fired
Cabinet Heaters
installation and operatinG Manual
Part No. 20-45-159
INDEX Section
Introduction and Document Index
Installation Requirements ................................................................................. 1
Installation Instructions ................................................................................. 2
Commissioning Instructions ................................................................................. 3
Servicing Instructions ............................................................................................... 4
Spare Parts ............................................................................................... 5
Fault Finding Guide ............................................................................................... 6
Replacing Parts ............................................................................................... 7
User and Operating Instructions .................................................................... 8
WARNINGS

Summary

Installation Requirements

Compliance and Safety Information

Outlines compliance with standards, directives, and safety precautions.

Fuel and Electrical Supply

Installation Procedures

Connection Requirements

Details flue, gas, and electrical connection procedures.

Commissioning

Pre-Testing and Checks

Outlines safety checks, installation verification, and system readiness before ignition.

Ignition and Burner Operation

Details the procedure for burner ignition, sequence verification, and lockout handling.

Air Delivery System Checks

Final Handover and User Information

Servicing

Planned Servicing Schedule

Major Component Servicing

Detailed steps for servicing key components like flue, fan, motor, pulleys, and heat exchanger.

System Checks and Burner Service

Service Re-commissioning

Fault Finding Guide

Replacement Parts Procedures

User Instructions

Commissioning and Handover

Operating Procedures

Covers start-up, stop, shutdown, ventilation, and lockout procedures for the user.

BENSON 300 Specifications

General

Brand	BENSON
Model	300
Category	Gas Heater
Language	English