BENSON 205 - User Manual

BENS O N
Benson equipment must be installed and maintained in accordance with the relevant provisions of the Gas
Safety (Installations and Use) Regulations 1998 for gas red products. Due account should also be taken of
any obligations arising from the Health and Safety at Works Act 1974 or relevant codes of practice. In addition
the installation must be carried out in accordance with the current IEE wiring regulations (BS 7671),
BS 6896 (Industrial & Commercial) and any other relevant British Standards and Codes of Practice
by a qualied installer. All external wiring MUST comply with the current IEE wiring regulations.
Benson Gas Fired
Cabinet Heaters
installation and operatinG Manual
Part No. 20-45-159
INDEX Section
Introduction and Document Index
Installation Requirements ................................................................................. 1
Installation Instructions ................................................................................. 2
Commissioning Instructions ................................................................................. 3
Servicing Instructions ............................................................................................... 4
Spare Parts ............................................................................................... 5
Fault Finding Guide ............................................................................................... 6
Replacing Parts ............................................................................................... 7
User and Operating Instructions .................................................................... 8
WARNINGS

Summary

Installation Requirements

1.7 Health and Safety

Essential safety precautions, PPE, and regulatory compliance.

1.10 Electrical Supply

Specifies electrical connection requirements and safety measures.

Installation

2.5 Flue Installation

Detailed steps for correctly installing the flue system.

2.6 Gas Installation;Connection

Safe procedures for connecting the gas supply pipework.

2.7 Electrical Installation;Connection

Guidelines for wiring and connecting the heater electrically.

Commissioning

3.1 Commissioning - Pretest

3.2 Commissioning - Ignition

Procedure for starting the burner and verifying ignition.

Fault Finding Guide

Burner Fails to Run

Troubleshooting steps for when the burner does not start or operate.

Burner Goes to Lockout

Diagnosing and resolving conditions causing burner lockout.

Failure to Establish Main Flame

Steps to fix issues with the primary flame ignition process.

Overheat Shutdown

Troubleshooting steps for shutdowns caused by excessive temperatures.

User Instructions

8.3 Start Up Procedure

8.4 Stop Procedure

8.5 Shut Down Procedure

8.7 Lockout Situations

What to do and check when the heater enters a lockout state.

BENSON 205 Specifications

General

Brand	BENSON
Model	205
Category	Gas Heater
Language	English