This Control panel can be programmed using the respective Software J400 release 1.0 or higher.
BENTEL SECURITYsrl shall not assume the responsibility for damage arising from improper application or use.
This Control panel has been designed and manufactured to the highest standards of quality and performance.
Installation of this Control panel must be carried out strictly in accordance with the instructions described in this manual, and
in compliance with the local laws and bylaws in force
The J424 and J408 Control panels comply with the essential requirements of standards EN54-2; EN54-4.
The J424 and J408 Control panels, all their accessories and functions, except those listed below and unless otherwise specified
(see notes marked A), are IMQ Security Systems Grade II Listed.
The J400-EXT Extinguishment Module is not IMQ Security Systems Grade II Listed.
BENTEL SECURITY srl reserves the right to change the technical specifications of these products without prior notice.
To Next Page
Loading...
