EXPRESS - Fancier
SAFETY INSTRUCTIONS AND INSTRUCTIONS AGAINST MANIPULATION
8
HB_EXPRESS_FANCIER-E_13.doc
Gantner Pigeon Systems GmbH
2. SAFETY INSTRUCTIONS AND INSTRUCTIONS AGAINST
MANIPULATION
2.1 Safety
•
After unpacking check the components immediately on possible damage.
•
Do by no means connect a damaged set to the mains or start using it. Report to your
authorized dealer immediately.
•
The components are to be opened and repaired only by the manufacturing firm or an
authorized service center. Unauthorized handling will lead to the loss of any warranty
claims whatsoever.
•
Never disconnect the power supply unit by pulling its cord. Instead get hold of its case
and gently pull it out.
•
The temperature surrounding the EXPRESS should not exceed +45 °C (+113 °F) or drop
down under 0°C (+32 °F). It may reach a temperature of +70 °C (+158 °F) for the loft
antenna. If the temperature has fallen below 0°C (+32 °F) – which means that
condensed water is possibly formed – take the EXPRESS to a place with a room
temperature of about +20 °C (+68 °F) and let it dry there for more or less one hour.
Afterwards the equipment can be used again without further problems. The storage
temperature for the winter season ranges between -25 °C (-13 °F) and +70 °C (+158 °F) for
the EXPRESS and between -20 °C (-4 °F) and +70 °C (+158 °F) for the loft antenna.
•
While in use, the EXPRESS should neither be exposed to rain nor to direct sunshine.
2.2 Manipulation
It is a fact that there is no 100% protection against manipulation. Yet the EXPRESS is
equipped with several technical devices and protective measures against manipulation.
Attention:
Despite the considerable technical and organisational measures taken the
possibility of manipulation can never be ruled out completely. It is explicitly stated here that
the manufacturer cannot guarantee for complete protection against manipulation.
To Next Page
Loading...
Need help?
General
