15
GENERAL TROUBLESHOOTING
The unit is not cutting level.
Level deck. Check air pressure of all tires; make
sure they are equal. See tires for maximum
inflation.
Without the engine running, make certain blades
are installed identically.
The engine will not start.
Disengage blades, turn key switch to the “OFF”
position, check battery and all other electrical
connections and inspect spark plug and wire.
Contact engine manufacturer or authorized and
qualified mechanic.
Engine runs poorly.
See engine manual.
Check adjustment of the throttle.
Replace fuel, clean fuel filter and fuel line.
Check spark plug and gap.
Cutter bounces excessively while towing.
Decrease tire pressure.
Tow at a lower speed.
The cutter vibrates abnormally.
The blade does not rotate freely on its support.
Check installation (see blade maintenance
section)
WEAR YOUR SAFETY GLASSES
FORESIGHT IS BETTER THAN NO SIGHT.
To Next Page
Loading...