5
ASSEMBLY
ASSEMBLY INSTRUCTIONS
IMPORTANT: UNLESS OTHERWISE SPECIFIED TORQUE ALL BOLTS ACCORDING TO TORQUE SPECI-
FICATION TABLE (SEE TABLE OF CONTENTS) WHEN STATED: TIGHTEN FIRMLY. REFER TO PARTS
BREAKDOWN SECTION FOR PART IDENTIFICATION.
Overall view
NOTE: In this manual, the right and left side is determined being seated on the driver’s seat.
Remove all the components from the shipping crate
except the assembled rough cutter in order to help
with the assembly.
INTENDED USE
The 44” Rough Cutter is designed to clear dense areas of grass and cut saplings in meadows and on small
estates. It is not intended to create a finish cut on lawns. Your Rough Cutter should be towed behind an ATV,
golf cart, lawn tractor or other approved vehicle with the help of a 2’’ reach ball hitch. It is not recommended for
speeds exceeding 5 mph
To Next Page
Loading...