12
OPERATION & TRANSPORTATION
BREAKING IN YOUR MOWER
Set the vehicle parking brake and chock the wheels.
While the engine is running, slowly engage blade
control.
In a safe environment, (i.e. no children or pets) allow
blades to rotate and engine to idle for 5 minutes,
breaking in the belt for a longer life.
Stop cutter.
STOPPING THE ENGINE
Make sure the tow vehicle parking brake is set.
Disengage cutting blades.
Reduce engine to idle speed and allow engine to run
momentarily for cooling.
Turn the key to the ’’OFF’’ position.
STARTING TO CUT
Adjust the cutting height using the height adjustment
knob on the control box.
Double check that the mower is well attached to
vehicle.
Following the instructions “Starting the engine” on the
preceding page, start the mower engine.
Engage the blades following the instructions on the
preceding page.
Start mowing at a slow travel speed.
STOPPING THE CUTTING SESSION
Bring tow vehicle to a complete stop, set the parking
brake and disengage blades.
Turn ignition key to the “OFF” position.
Always remember to remove keys to avoid accidental
starting and irresponsible usage.
SUGGESTED MOWING PRACTICES
Operate mower engine at full throttle to assure the
best cutting performance and maximum material
discharge.
Allow wet grass to dry. Clumps of wet grass will
collect under the mowing deck.
Mowing should be started with tow vehicle in low gear
and increased only as safe mowing conditions permit.
This speed should not exceed 5 mph.
The average lawn should be cut to approximately 2.5”
during the cool season and to over 3” during the hot
months.
For a healthier lawn and better esthetics, your lawn
should be mowed often and after moderate growth.
When cutting high or dense grass areas, go slowly.
Some areas may need to be mowed twice. The
second cut should be at 90 degrees to the first, if
possible.
Do not attempt to cut areas that the tow vehicle
cannot maneuver through and/or slopes that you do
not feel comfortable riding.
TRANSPORTING MOWER
Stop mower properly and wait for all moving parts to
stop.
Place mower deck in its highest position.
If transporting without the use of a tow vehicle, then
remove spark plug wire and place where it cannot
To Next Page
Loading...