Why does the chute on my Bercomac PRESTIGE 54 Snow Blower plug easily?
The chute of your Bercomac Snow Blower might be plugging easily because the engine isn't at full R.P.M. Ensure the engine is running at full R.P.M. when using the snowblower. Also, you might be advancing too quickly. Reduce your speed and allow the snowblower to ingest snow at its own pace.
How to fix a vibrating or noisy Bercomac PRESTIGE 54 Snow Blower?
If your Bercomac Snow Blower is vibrating or making unusual noises, it could be due to several reasons: * A damaged pulley, which would require a pulley replacement. * A damaged bearing, which would require a bearing replacement. * A damaged fan, which means you need to dismount and repair or replace the fan. * One or both sections of the auger being bent, which would require replacing the bent section(s).
What to do if the auger on my Bercomac PRESTIGE 54 stopped turning?
If one or both sections of the auger on your Bercomac Snow Blower aren't turning, the shear bolt is likely broken. Replace the shear bolt. See the Parts List "Snowblower" for identification.
Why my Bercomac Snow Blower stopped turning?
If your Bercomac Snow Blower has stopped turning, the belts might be damaged or snapped. Check and replace any damaged belts.
How to fix a difficult chute rotation on a Bercomac Snow Blower?
If you're finding it hard to rotate the chute on your Bercomac Snow Blower, it could be because of dirt or ice. Clean the base of the chute and the rotation ring. Also, lubricate the chute inside and out, as well as the rotation worm. Alternatively, the base of the chute might be damaged or bent, in which case you should replace the defective parts.
Why is the belt on my Bercomac PRESTIGE 54 Snow Blower worn at a specific point?
If the belt on your Bercomac Snow Blower is worn at a specific point, it might be because the snowblower was engaged when it was already plugged. Ensure the auger and fan are clear of obstructions or ice before engaging the snowblower.
How to prevent my Bercomac PRESTIGE 54 Snow Blower from digging into the ground?
If your Bercomac Snow Blower is digging into the ground, it's likely because the ground isn't frozen or is too soft. Adjust the skid shoes lower to better support the snowblower.
Why doesn't my Bercomac PRESTIGE 54 raise evenly?
If your Bercomac Snow Blower isn't raising evenly, it's likely due to uneven tire pressure. Verify and adjust the snowblower tire pressure to 50 p.s.i.
What to do if the electric motor on my Bercomac PRESTIGE 54 Snow Blower doesn't work?
If the electric motor of your Bercomac Snow Blower isn't working, it might have overheated. These motors have an internal protector; wait 10 minutes before using it again.
General| Type | Two-stage |
|---|---|
| Clearing Width | 54 inches |
| Impeller Diameter | 14 inches |
| Number of Impeller Blades | 4 |
| Throw Distance | up to 50 feet |
| Transmission | Hydrostatic |
| Warranty | 2 years |
| Tires | 16 x 6.5 inches |
To Next Page
