P
age | 18
T
roubleshooting Guide
P
ROBLEM
P
OSSIBLE CAUSE
P
ROBABLE CORRECTION
T
he machine
doesn't
operate
The ice maker is unplugged Plug the ice maker in
T
he fuse is blown
Replace fuse If it happens again,
call for service to check for a short
circuit in the ice maker
T
he ice maker power switch is
OFF
Turn the ice maker power switch ON
T
he ice storage bin is full of ice
Remove some ice Make sure water
curtain and micro-switch are closed
T
he water doesn't
feed in after the ice
maker starts
The water supply tap is turn off Turn on the water supply line
T
he water supply pipe is not
proper connected
Reconnect the water supply pipe
M
achine makes ice,
but bin does not fill
up with ice
The condenser may be dirty Clean the condenser air filter.
T
he air flow to the ice maker
may be obstructed
Check the installation
T
he ambient and water
temperatures are high, or the
machine is near some heat
source
Check the installation
W
ater is leaking from
the unit
A few water drops fall to the
floor when you open the door
to take out ice from ice storage
bin
Normal condensation on the door or
some water together with ice Take
care when you take out ice
W
ater supply connection leaks
Tighten fitting. See “Connecting the
water line”
C
ubes are partially
formed or white at
the bottom
Not enough water in the
water trough
Check if the water supply
pressure is below 15 psig
C
heck water supply--filter may be
restricted
C
heck for a water leak at the water
trough
N
oise during operation
The feet are not leveled
and locked
Level and lock the feet
See “Leveling the Ice Maker”
C
ertain sounds are normal See Normal Sounds
T
he ice maker stops
suddenly while
making ice
The electricity is off
Reconnected the power
supply line
T
he room temperature is out
the stated range
Cut off the electricity, let the ice
maker stop working until the
temperature returns within the
stated range
T
he ice storage bin is full of ice
R
emove some ice cubes; Make sure
the water curtain and micro-switch
T
he body of the ice
maker is electrified.
The grounding line isn’t in the
socket
Use a socket meeting the required
electrical standard
S
caling occur
frequently inside
T
he hardness of the water is
too high
U
se a water-softening device in-
i
n front of the water inlet
To Previous Page
Loading...
