EasyManua.ls Logo

BERG BC650N - User Manual

BERG BC650N
18 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
P
age | 1
S
ERVICE, INSTALLATION, AND INSTRUCTION MANUAL
F
or AUTHORIZED PARTS or TECHNICAL SERVICE, please contact:
1-877-368-2797
FOR SOME MODELS the POWER SUPPLY CORD is NOT INCLUDED.
MUST HAVE A 3-PRONG GROUNDING PLUG.
3355 Enterprise Avenue, Suite 160, Fort Lauderdale, FL 33331
BC36
0N-BC360NH
BC370N-BC370NH
BC500N-BC500NH
BC650N-BC650NH
BC10
00N-BC1000NH
COM
MERCIAL ICE MACHINE
PL
EASE READ CAREFULLY

Table of Contents

Questions and Answers

  • M
    Michael LeeAug 15, 2025
    How to fix a BERG BC650N Ice Maker that doesn't operate?
    • A
      andersonrichardAug 15, 2025
      If your BERG Ice Maker isn't working, there are several potential reasons: * It might not be plugged in, so ensure it is properly connected to a power outlet. * A blown fuse could also be the culprit; try replacing it. If the issue persists, it may indicate a short circuit, requiring professional service. * The power switch might be off; make sure it's turned on. * If the ice storage bin is full, remove some ice to allow the machine to operate. Also, ensure the water curtain and micro-switch are closed.
  • N
    Nicholas JonesAug 18, 2025
    Why does my BERG Ice Maker stop suddenly?
    • K
      Kim HallAug 18, 2025
      If your BERG Ice Maker suddenly stops while making ice, consider these possibilities: * Check if the power supply line has been disconnected and reconnect it. * The room temperature may be outside the specified range. If so, disconnect the power and allow the ice maker to stop working until the temperature returns to the normal range. * The ice storage bin might be full. In this case, remove some ice cubes and ensure the water curtain and micro-switch are closed.
  • M
    Michael JohnsonAug 21, 2025
    What to do if my BERG BC650N Ice Maker is leaking water?
    • C
      Carl JohnsonAug 21, 2025
      If water is leaking from your BERG Ice Maker, here are a couple of things to check: * A few water drops are normal when you open the door to take out ice due to condensation or water on the ice. Be careful when removing ice. * If the water supply connection is leaking, try tightening the fitting.
  • R
    Robert HuffAug 25, 2025
    Why is my BERG BC650N Ice Maker making ice but not filling the bin?
    • F
      frankdunnAug 26, 2025
      If your BERG Ice Maker makes ice, but the bin isn't filling up, consider the following: * The condenser might be dirty, so clean the condenser air filter. * The airflow to the ice maker might be obstructed; check the installation. * High ambient and water temperatures, or proximity to a heat source, can also affect ice production; check the installation.
  • M
    Mr. Keith FordAug 28, 2025
    What to do if water doesn't feed into my BERG BC650N Ice Maker?
    • T
      Tanya MillerAug 28, 2025
      If water isn't feeding into your BERG Ice Maker after it starts, consider these possible causes: * The water supply tap may be turned off. Ensure the water supply line is turned on. * The water supply pipe might not be properly connected. Reconnect the water supply pipe.
  • J
    Jeremy RodriguezAug 31, 2025
    Why are BERG BC650N Ice Maker cubes partially formed?
    • M
      Mr. Jeremy GriffinAug 31, 2025
      If the ice cubes from your BERG Ice Maker are partially formed or have a white bottom, consider the following: * There might not be enough water in the water trough. Check if the water supply pressure is below 15 psig. * The water supply filter may be restricted. Check the water supply. * Check for a water leak at the water trough.
  • D
    Darrell MelendezSep 3, 2025
    Why is my BERG BC650N Ice Maker making noise?
    • W
      wromeroSep 4, 2025
      If your BERG Ice Maker is making noise during operation: * Ensure the feet are leveled and locked. * Certain sounds are normal during operation.
  • R
    Richard EdwardsSep 7, 2025
    How to prevent scaling in BERG BC650N Ice Maker?
    • P
      Patricia GibsonSep 7, 2025
      If scaling occurs frequently inside your BERG Ice Maker, it's likely due to the hardness of the water being too high. Consider using a water-softening device installed in front of the water inlet.
  • S
    Seth NormanSep 12, 2025
    Why is the body of my BERG BC650N electrified?
    • J
      jacksonstevenSep 12, 2025
      If the body of your BERG Ice Maker is electrified, it could be due to the grounding line not being properly connected in the socket. Use a socket meeting the required electrical standard.

Summary

ICE MAKER SAFETY

SAFETY ALERT SYMBOL DEFINITIONS

Explains DANGER, WARNING, and CAUTION symbols used in the manual.

IMPORTANT SAFETY PRECAUTIONS

Basic precautions to reduce risk of fire, electric shock or injury during operation.

IMPORTANT SAFEGUARDS

DANGER AND WARNING PRECAUTIONS

Specific DANGER and WARNING warnings for installation, environment, and proper usage.

ICE MAKER INSTALLATION

UNPACKING AND LOCATION

ELECTRICAL REQUIREMENTS AND BIN ATTACHMENT

ELECTRICAL SAFETY WARNINGS

Critical DANGER warnings for proper electrical grounding and connection.

POWER AND WATER CONNECTIONS

GROUNDING AND POWER SUPPLY

Steps for grounding and connecting the power supply line to the unit.

WATER SUPPLY HOOKUP

INSTALLATION TYPES AND OPERATION STARTUP

OPERATION CHECKLIST AND CONTROL PANEL

CONTROL PANEL OPERATION DETAILS

CLEANING AND MAINTENANCE OVERVIEW

EXTERIOR AND INTERIOR CLEANING

SPECIFIC CLEANING PROCEDURES

WATER DISTRIBUTION TUBE AND ICE-MAKING SYSTEM CLEANING

Instructions for cleaning the water distribution tube and the ice-making system.

CONDENSER CLEANING AND TROUBLESHOOTING PREP

CONDENSER CLEANING

PREPARING FOR TROUBLESHOOTING

Guidance on initial troubleshooting steps before contacting technical support.

TROUBLESHOOTING GUIDE

BERG BC650N Specifications

General IconGeneral
BrandBERG
ModelBC650N
CategoryIce Maker
LanguageEnglish

Related product manuals