CONTROL PANEL
OPERATION
• STARTING – After the power and water supply have been properly connected, switch the machine on by pressing the
ON/OFF button on the display panel
• PRE- COOLING – The inlet valve will automatically open once the machine is turned on. The evaporator will pre-cool for 30
seconds before water pumping will start. The compressor will start, and the water pump will stop running. The inlet valve
will remain open until reaching the specied level.
• ICE-MAKING – The water pump will begin working after the machine has pre-cooled for 30 seconds. The water will ow
continuously through the evaporator and will form ice cubes in the ice tray.
• ICE FALL – When the machine has reached its capacity the pump will shut down and the frost valve will open allowing hot
air into the evaporator. In approximately 1-2 minutes, the ice from the evaporator will fall into the ice bin. In order to avoid
injury, do not put your hands into the ice bin during this process.
• SHUTDOWN – If the machine is running and needs to be shutdown, click the ON/OFF button on the control panel
• FULL ICE BIN – The machine will automatically stop when the ice bin is full. The machine will automatically restart when
the ice bin has been emptied.
THE MACHINE WILL STOP WORKING WHEN THE FOLLOWING OCCURS:
• The ice does not fall after 3 attempts
• The ambient temperature exceeds the maximum temperature allowed (100°F)
• The machine runs out of water
November 2020
To Next Page
Loading...
