tion and communication of its content is
prohibited, unless with our express permission. All rights reserved. Damages will be payable in case of in-
fringement.
Disclaimer
The content of this publication was checked for compliance with the hardware and software described. How-
ever, discrepancies may arise, therefore no liability is assumed regarding complete compliance. The infor-
mation in this document will be checked regularly and all necessary corrections will be included in subse-
quent editions. Suggestions for improvements are always welcome.
Subject to technical changes.
Trademarks
CANtrol
®
and CANtrol
®
- dialog are registered trademarks of Berghof Automation GmbH
Microsoft
®
, Windows
®
and the Windows
®
Logo are registered trademarks of Microsoft Corporation in
the USA and other countries.
EtherCAT
®
is a registered trademark and patented technology, licensed from Beckhoff Automation
GmbH, Germany.
CiA
®
and CANopen
®
are registered community trademarks of CAN in Automation e.V.
All rights reserved by the individual copyright holders.
General Information on this Manual
This equipment manual contains product-specific information valid at the time of publication.
This equipment manual is only complete in conjunction with the product-related hardware and software user
manuals required for the individual application.
You can reach us at:
Berghof Automation GmbH
Harretstr. 1
72800 Eningen
Germany
T +49.7121.894-0
F +49.7121.894-100
e-mail: controls@berghof.com
www.berghof.com
Berghof Automation GmbH works in accordance with DIN EN ISO 9001:2000.
To Next Page
Loading...
