2. Product description EC1000
2.1. Overview
The EC1000 is a CODESYS PLC controller with a broad range of data interfaces.
In compliance with IEC 61131-3 the module can be programmed either with version 2.3 or 3.x.
Installation
The EC1000 is designed for installation in switching cabinets on a DIN mounting rail in a rough industrial
environment. The fanless design and the flash memory make the cost and effort for maintenance minimal.
Ethernet
A 10/100 Mbit/s Ethernet interface is available. Thanks to the TCP/IP and UDP/IP protocols it is possible to
link it very variably to visualisation software, to higher order control units or to the IT infrastructure.
EtherCAT interface
An EtherCAT E-bus interface with a lateral 10-pin connection is available.
USB
The USB host interface provides a widely-used peripheral interface. For example, it can be used to carry out
an application update or data migration simply via a USB stick. Please contact our Technical Support if no
driver support is available for a specific USB device.
CAN Interfaces
The EC1000 possesses 1 standard CAN interface which can be used up to 1 Mbit/s.
Serial Interfaces
The RS232 can also be used as a programming interface.
Realtime clock
An accumulator battery-buffered, maintenance-free realtime clock can be set at the current time via a soft-
ware interface.
SD card
The EC1000 possesses 1 SD card slot, e.g. for data copies.
Slot extension
Optionally, for communication purposes a slot is available for an extension module on the left-hand side.
Applicable interfaces are LAN, CAN RS485 or RS232.
Visualisation
CODESYS Target and Web Visualisation are included in the scope of supply. An easy-to-use display is availa-
ble with the Berghof ET1000 Ethernet Terminal.
Networking
PROFINET device and BACnet controller function as a software option.
To Next Page
Loading...
