SAFETY
Before you use read the following safety instructions.
1. Read all the safety in formation and instructions before using the product. When passing this product
to someone, include all documents.
2. If you do not follow the operating instructions provided, it may compromise the safety of your product
and this may invalidate the warranty.
3. Do not expose the product to dripping or splashing. Do not place objects filled with liquids, such as
vases, on the product.
⚫ If liquid or water spills onto the product, switch it off immediately and contact your dealer.
⚫ If you are using a mains-powered adapter, do not touch the product with wet hands.
4. The internal battery in this product is not user replaceable. Do not expose the battery to excessive
heat or naked flames. Ensure adequate ventilation and airflow around the product, particularly
when charging.
5. Using the product in rooms or climates with high humidity and temperatures may cause
condensation to form inside the product, which can damage the product. Use the product in
moderate climates only.
6. Do not use your product in extremely hot or cold temperature. Keep the device away from heat
sources, such as radiators or gas/electric fires. Do not expose your product to naked flames, such as
lighted candles.
7. To charge your product, only connect it to a supply source that meets the safety
8. Isolation requirements of EN 62368 or EN 60950-1 for an accessible safety extra low voltage circuit.
For this connection, use either the supplied micro-USB cable or a suitably CE approved power
adapter with the correct USB output rating.
9. Power the product using an external 5V DC 1 A power supply. The maximum output current is 1 A,
protected by an internal circuit.
10. Before you charge your product, ensure that the available supply voltage corresponds with the
required operation al voltage of the product.
11. Disconnect your product from the charging power supply if you will not use your product for a long
period of time (for example, if you are going on holiday).
12. Always unplug your product from the charging power supply before cleaning. When cleaning the
product, do not use any type of abrasive pad or abrasive cleaning solutions as these may damage the
product's surface.
13. To reduce the risk of electric shock, do not remove any screws. The product does not contain any
user-service able parts inside. Product repairs should only be carried out by authorised personnel.
To prevent possible hearing damage, do not listen at high volume levels for long periods of time. Consistent
exposure to high volumes when using headphones can damage your hearing. Always check the volume level
before you insert headphones (not provided) into your ears. Use of headphones while operating a vehicle is
To Next Page
Loading...
