Berkel 827 - Reassembly

I~
,~\
IX REASSEMBLY
1. Position center plate knife guard. Hold in both hands
and DO NOT place fingers under the edge of the guard.
2. Place guard over the knife.
3. Tighten knife center plate knob.
4. Replace slicer deflector.
5. Replace product table. Hold the product table with both
hands and lower it carefully in place. Remember that the
pusher is loose and can slide.
6. Tight.en the locking knob.
7. Move. the pusher back and forth and coat the rod with a
thin film of Berke! oil.
8. Check: guards. Make· sure slicer deflector, sharpener and
center pl.ate knife, guard ,are in. pla.ce. and clear of the
knife~ Also1 make sure that the product table moves ·back
and forth easily.
9. Clean slicer base. Use a cloth and cleaning solution.
Rinse with hot water. · Spray with sanitizing solution
and let air dry.
10. Plug in the power cord
· YOUR SLICER IS· NOW SHARPENED, CLEANED AND SANITIZED
-- READY TO USE.
(7)