Berkel 827 - ELECTRICAL FAILURE; THICKNESS CONTROL KNOB NOT OPERATING GAUGE PLATE

!\ ..
C. ELECTRICAL FAILURE
D.
1. Is slicer fully plugged into a properly grounded
120/AC outlet? If properly connected, the red
warning light should be on when switch is in the
ON position.
2. Inspect power cord. Has it been damaged, cutting
off electrical flow?
3. Is ON-OFF switch in the ON position?
4. Are you·getting electricity from the wall outlet?
Check by plugging in another piece of equipment with
the same elec't.rical requirements. Also, check
circuit breaker or fuse.
s... If you are getting electrical power and your slicer
is still not operating, contact your Berkel service-
man.
THICKNESS CONTROL l<NOB NOT OPERATING GAUGE PLATE
If the thickness control knob is not opening and closing
the gauge plate properly, it is a sign that the internal
m!J<::hanism has suffered some loss of adjustment. DO NOT
try to adjust the mechanism yourself. Have it done by
your Designated Berkel Service Location.
If correction of any of the above conditions does not
result in a functional slicer, call your Designated
Berkel Service Location.
(9)