Safety | Safety Instructions |
5
Omega | Installation and Operation Guide | Rev A | Doc P/N: PIEAE21-OMEGA
Safety Instructions
Prior to performing any work on the Omega controller, become familiar with the following safety concerns:
General Safety Instructions
Read this installation and operation guide prior to installing and servicing
the system.
Pay careful attention to all cautions and warnings in this guide.
Installation must comply with all local electrical and plumbing codes.
It is recommended that a licensed electrician performs all electrical
connections. Improper installation could result in shock or fire hazard.
Omega is not intended for use by children.
Battery Safety Instructions
BERMAD is not responsible for battery failures due to mishandling.
Do not crush, break, or disassemble the batteries.
Do not damage the battery label, which acts as an electrical insulation for
the battery can.
Do not install the batteries backwards, put in fire, submerge in fluids, or mix
with other battery types.
Do not weld or solder the batteries onto the battery compartment.
Dispose of batteries in accordance with local regulations.
Internal batteries are intended for operating in offline mode.
Contact BERMAD for battery replacement when depleted or damaged.
External Power Source Safety Instructions
Before connecting to an external power source, ensure the external power
polarity matches the one marked on the Omega connector board.
The power supply cables must first be connected to the Omega power
connectors before plugging into an external power source.
The Omega controller must first be unplugged from the external power
source before disconnecting the power supply cables from the power
connectors.
WARNING: Contact with
electrical equipment and
connections can cause electric
shock if the power supply is
turned on.
To Next Page
Loading...
Need help?
General
